E-Z water

[keithatsibford]

 
I need to remodel some E-Z water and instructions say that a hot gun will do the job. I can't find out what sort of heat is needed. Woodland's say 160 to 185deg but most guns only give wattage output. Can anybody give me advice?
Many thanks - Keith

[invercloy]

Keith, it depends on the extent of the remodelling you want to do.  Are you just wanting to create some surface texture or move big lumps of it about?

If you're just re-doing the surface then perhaps a hair dryer would do if you have access to one.

[berryr99]

I have used the end of a soldering iron to re-model small areas

Bob