Hi , I have printed a L&B inpired brake/parcels wagon which I compiled from about 4 different files on Thingiverse for the various details. Looks ok I think, but having printed the body another couple of times I am getting the stringing effect as shown in the image. The back one is the original and the near one is the newer versin. No changes were made in the file so I am wondering how this might have happened and what I can do to prevent it happening again?
The threads break off with little or no evidence that they existed, so it is not a huge issue, but it is a waste of filament and just a little confusing/frustrating.
Any tips to why this may be happening after a successful first print? The only change I think that may have affected this was a firmware update in BambuLab software, but other prints are still printing fine, it is just this file that is seeing this change. Just wondering if there is a setting or two I can look at, or maybe I just need to drill into the file much deeper to see if there any errors that have been exaserbated with the firmware update. Thanks