I know it has probably been covered in these forums before, but could some kind soul please give this old idiot a simplified run-down on programming two of these to operate points numbered 1- 16 ?
I know that each module is programmed as two groups - 1-4, 5-8 and the second module, 9-12, 13-16
but how ? And do i have to have a point motor conected to the module when programming ?
Many thanks.
This is the manual for this decoder
https://www.roco.cc/uploads/documents/pdf/10775.pdf
and a note about Roco Address offset
https://www.newrailwaymodellers.co.uk/Forums/viewtopic.php?t=50439