Esteemed gents,
A few months ago, I obtained a built version of Backwoods Miniatures powered crane from the OO9 sales team. It appears to be the first version produced, not the one that is currently shown on the website. I would like to make some modifications, but am in need of a set of instructions to help me understand how the pieces fit together, particularly the parts fastened with screws. Any idea where I might obtain a set?
Jeff S.
Yes the early versions had an outside frame chassis not the kato chassis.
(https://forum.009society.com/proxy.php?request=http%3A%2F%2Fi663.photobucket.com%2Falbums%2Fuu358%2FM-e-l-l-o-w%2FNGRM%2520On-Line%2FBackwoodsCrane.jpg&hash=e492927c2a927f46446381cfce68f472d0d36708)
It must be getting on for 20 years ago now I built this, but I am sure I have the instructions for building this kit.
However like most backwoods kits the idea is that once assembled you can not get them apart again to maintain the motor.
I will have a look when I get a chance this evening, unless someone else beats me to it!
Brian Meldon
Thanks, Brian.
Jeff S.
Recently completed the chassis on mine, it's noisy as hell. I have the instructions if Brian can't help you.
Mal.
Quote from: WALLSHIRTS on June 30, 2017, 19:10
Recently completed the chassis on mine, it's noisy as hell. I have the instructions if Brian can't help you.
Mal.
The one I picked up is noisy, too. It adds to its character. ;D
I will let you know, if Brian cannot find his instructions.
Jeff S.
Not found them yet!
However if you want to get to the motor then you may well be out of luck as if the builder followed the instructions from memory they will not come apart again! This is a common feature off many Backwoods kits.
Brian Meldon
I have managed to remove the roof from the body. It appears that the majority of the kit was assembled using CA. I believe there are four screws holding the body to the chassis. Removing them will hopefully get me to where I need to be.
Jeff S.
Success! I have removed the body of the steam crane from the chassis. I had to remove the wires from the motor contacts to completely remove it, but it's done. Brian M. was right. It certainly wasn't designed to be taken apart, but I've managed. The next test will be trying to put it back together.
Jeff S.